PrintYourMonsters
patreon
NEWS
🕑 Added 2020-05-02 21:53:56 +0000 UTCHi all! Here is the NEWS :)
- The Kaiju is on the drive (Pre-supported version in few days)
- 180 dwarf BASES +PDF (in few minutes :) made by my son Dylan
- Orcus Demon (available in few days)
- GRAVEYARD ELEMENTAL (available in few days)
- A mutant of My OWN creation (pics in 2 days)
- For the Undead Pirates Project
- 3 new pirates (available in few days)
- 1 New boat 'I have to start it :)
Painting contest
- No painting contest for the moment (sorry, but last month I had only 2 participants)
- The Mars winner is Magnus Nilsson! Congratulations for this amazing painting job!!!
The Poll
A new poll with monsters in few days!
Keep safe my friends and good prints :)
Emmanuel
Comments
Silver Version
You should do them almost upright but tilted a few degrees to one side so that the bottom is down. Most of the supports go on the bottom reducing the blemishes on detail and cleanup work on the top. You dont want to make them flat because it creates a huge amount of suction on the FEP which causes warping, failures, or a need for much stronger supports.
Dylan's bases are awesome, please give him my thanks! I've been working on Aztec bases for my current army. Does anyone have advice for supporting bases, though? Seems like it should be simple, but I either a) have a really tough time prying them off the build plate if I do it flat or b) have some slight warping and sanding needed on bottom due to heavy supports.
CycyX
Nice! Thanks again for all the work Emmanuel. ;)
