printshootrepeat patreon

Finnish Brutality Rifle Setup With @FirepowerUnited

🕑 Added 2024-11-19 13:37:29 +0000 UTC

Comments

кошка Нэко

Hi. I'm just getting into 3D printing, but have a lot of respect for what you're doing. I was wondering if you know about filament printing with metal from Virtual Foundry? You can buy inconel 718 filament, it's a strong steel that is used in aerospace. After printing you need to synterize in a special furnace (laboratory furnace at about 1300 degrees), usually such a furnace costs about 2000$, but you can synterize in someone else's furnace. I am wondering if it is possible to print a barrel using this method, thus getting almost 100% guns out of print? I found information about this printing on Integza's channel - he printed a nozzle for a homemade rocket out of steel. Not commercial in any way, actually became a patron to ask this! Thank you!