ForgeCore
patreon
Switch Spinning Storage Container
🕑 Added 2024-02-02 21:05:43 +0000 UTCThis is a super fun print, and can be very profitable as well. Spinning the games is very satisfying and it randomizes your game if you can't decide what you want to play. This design was complicated to get dialed in, but it finally works great!
Components you'll need to order.
1. The Magnets: Small Round Magnets (Amazon) (same magnets as all other prints)
You'll need 22 magnets per spinner
2. Bearings: Fidget Spinner Bearings (Amazon)
You need just 1 bearing per spinner
3. Stick on Rubber Base (Optional): 58mm Anti-Slip Silicone (Amazon)
You need just 1 per spinner
Comments
ForgeCore Co
Which magnets are loose? The magnets in the slots should be loose. But the magnets in the base shouldn’t be loose. Any magnets in the base need to be secure, adding super glue will be fine that’s what you need to do
Hey, in the assembly video you say what to do if the magnets are too tight, but will it still work if they fit loosely? I do not have any adhesive that will not damage the magnets if directly applied.
ForgeCore Co
Yeah They’re based off how long it takes me to print them on my Bambu Lab
Barry Beach
Just wondering if your print time estimates are based on the Bambu Lab printer and the speeds you set in your slicer? I usually set my infill and wall speeds to 120 for my Ender 3 V3SE and I get no less than 6 hours for all three parts.
ForgeCore Co
3D gloop
SkysThLimit
what kind of glue did you use for the disk, my magnets keep popping the disk loose and getting all stuck together
ForgeCore Co
The files for the disc are in the same sections as the rest of the STL files!
Hello! Where do you get the disk? I don’t see a link for it and there’s no mention of it until the assembly video that I can see. :) Thanks!
